Steps to move a upright piano

Pianos routinely make movers yearly list of products that are most often harmed. Grand pianos are specifically problematic. Practicing the following treatments for dismantling, padding and loading grand pianos will prevent damage, lower claims cost, and enhance consumer complete satisfaction.

1) At least 3 individuals are required to handle an infant grand piano. If the infant grand piano requires to go up or down stairs or if a full or concert grand piano requires to be carried, a minimum of 4 individuals are required.

2) Constantly complete a precise and comprehensive stock. It might be more effective or needed to use a visual inventory to adequately describe and show pre-existing damage.

3) As various parts are dismantled, please location all hardware in an appropriately labeled parts bag and after that place the parts bag in a "Components Box".

4) Eliminate the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a tidy furnishings pad.

5) Disconnect the lid by getting rid of the hinge pins. Have someone wiggle the lid, holding it opposite the hinge, while a 2nd person works the pin loose. Please take care not to harm the wood with the pliers or with the pin itself. Cover the jaws of the pliers with a little cloth to assist prevent damage to the wood if necessary. Wrap the lid in a tidy furniture pad.

6) Eliminate the prop that holds the cover open and wrap it in a clean furniture pad. The prop has a hinge pin and is in 2 pieces.

7) Remove the pedal assembly and wrap it in a tidy furnishings pad. The braces at the rear of the assembly rest in slots at each end. When getting rid of the screws, please beware not to drop the braces. In addition, please be specifically mindful with the push-rods so that they will not get bent. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by putting a piece of masking tape with the proper number on each rod. Note: If masking tape is unavailable, please use properly identified parts bags for this function. When reassembling at location, please make certain to put the rods in the appropriate order so that the pedals will work effectively.

8) Pad the piano by putting a clean rolled furnishings pad (stretch-wrap the pad to prevent it from unrolling) on the cover of the keyboard to prevent it from flopping open while you handle the piano. Keep in mind: Please guarantee that the surface of the piano is dust-free prior to padding it.

9) Position a piano board and attach the straps so that it is ready to get the piano. The raised brace on the piano board ought to be at the keyboard end of the piano.

10) Remove the left front leg check my blog by placing one person beneath the piano at the left end of the keyboard. The other two people must support the left front corner. The person beneath the piano need to turn the keeping block so that the long end points away from the leg. The screws, if there are any, need to then be removed. The "below" person ought to then extricate the piano prior to actually getting rid of the leg. Be sure to have two individuals raising the corner of the piano while the 3rd person eliminates the leg. Note: Please make certain to note which legs were removed from which positions considering that some pianos have legs that are not interchangeable.

11) Place the piano on the piano board by lowering the "leg-less" end onto the board. Please be sure to raise the entire piano slightly while finishing this maneuver to prevent excessive pressure on the remaining, attached legs as the piano suggestions. Be sure that the piano is focused snugly versus the brace at the end of the piano board.

12) Eliminate the 2 remaining legs and cover them in clean furniture pads. These legs are kept in place by a "key and slot" plan. To eliminate the leg, slide it inward towards the center of the piano until it comes out of the slot.

13) Protect the piano to the a fantastic read piano board by bringing the ends of the straps together and fastening them. Place folded burlap pads over the furniture pads however under the straps to supply extra security to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, tie the loose ends of the two straps together.

14) To move the piano over a flat, level surface area, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.

15) To move the piano up or down stairs, use the piano board as a skid. After sufficiently padding the stairs for security versus residence damage, put the keyboard end of the piano toward the bottom of the stairs. Attach a hump strap to the leading end of the piano board to avoid the piano from slipping.

16) To fill the piano, leave it on the piano board and location it in a tier as the very first base product with the keyboard facing the wall of the preceding tier. The finest location to load the padded lid is between the piano and the preceding tier or between the wall and the piano.

Although grand pianos represent a considerable difficulty, they can be moved without damage by utilizing sound judgment and practicing the treatments listed above.

Leave a Reply

Your email address will not be published. Required fields are marked *